Propulseur d'étrave/de poupe Side-Power SE60 IP 24 V

À propos de ce produit

SE60 IP tunnel bow/stern thruster 24V — 60kg of thrust (73kg at 24V), sized by Sleipner for boats of 9-12m (30-39ft). Standard on/off version, ignition protected for petrol boats and wet stern installations. Fits a 185 mm tunnel and can be installed in the bow or, with a Sleipner stern tunnel, at the stern.

What you get, and what to order with it

This is the thruster unit: motor, gear leg, single propeller, motor bracket and electronics. To complete a new installation you also need a 185 mm tunnel (GRP, aluminium or steel to suit the hull), a control panel, an ANL 150 fuse and holder, and battery cable sized to the run. The matching items are listed under “You may also need” below, and we will check the whole kit against your boat before it ships.

Caractéristiques

• Ignition protected (ISO 8846) — sealed electrics for petrol boats and stern installations that may get wet
• Intelligent Power Control (IPC) — minimal delay on direction change to reduce wear, with solenoid monitoring that stops the thruster automatically if a contact locks in
• Q-Prop™ five-blade skewed propeller — Sleipner measure up to 75% less noise than a conventional propeller
• Galvanic separation between motor and gear leg to protect against stray-current corrosion
• Overheat protection — shuts down (on/off models) or derates (PRO models) before the motor is damaged
• Ceramic shaft seals et sealed drive lubrication — no oil feed to plumb
• Flexible installation — mounts at any angle on the tunnel; the motor can be turned 90° on the bracket

Power and battery

Draws 170A at 24 V for a 2–3 minute duty cycle. Sleipner specify a battery of at least 280 CCA (EN) close to the thruster and an ANL 150 fuse. If the thruster battery is more than a few metres from the unit, size the cable with our battery bank and cable size calculator, and use the thruster size calculator to confirm SE60 is the right size for your boat.

Manuals and documents

• EU Declaration of Conformity (PDF)
• Control system and joystick compatibility (PDF)
• Installation manual (PDF)
• User manual (French) (PDF)
• User manual (German) (PDF)

Commander

Genuine Sleipner (Side-Power) product, part no. SE60/185S2-24IP. Special order from Sleipner — the lead time is usually 7–10 days, confirmed before payment, and units are typically air-freighted. Worldwide shipping with freight quoted at actual cost, never marked up. Sleipner’s manufacturer warranty applies (terms in the user manual); as a special-order item it is returnable only if faulty — see our Returns & Refunds Policy.