Side-Power ERL170 eVision ชุดขับเคลื่อนหัวเรือ/ท้ายเรือแบบพับเก็บได้ 48V

เกี่ยวกับผลิตภัณฑ์นี้

ERL170 eVision retract bow/stern thruster 48V — 170kg of thrust, sized by Sleipner for motor boats and sail boats of 15–22 m (49–72 ft). A brushless eVision low-profile retractable thruster: it deploys below the hull when you need it and retracts into its housing when stowed, so there is no open tunnel and no drag under way. Variable-speed control over S-Link and continuous run time at full thrust.

What you get, and what to order with it

This is the thruster unit as supplied by Sleipner. Retract thrusters install in their own hull housing — the installation manual below gives the hull cut-out and mould dimensions. You also need an S-Link control panel (a PJC211 or PJC212 joystick, or a Sleipner touch panel), an ANL 200 fuse and holder, and battery cable sized to the run. The matching items are listed under “You may also need” below, and we will check the whole kit against your boat before it ships.

คุณสมบัติ

• Brushless eVision motor with continuous run time at full thrust (at 22 °C ambient, typically limited only by battery capacity)
• Variable-speed (proportional) control — apply only the thrust the manoeuvre needs, quietly and precisely
• S-Link™ CAN-based control with plug-and-play signal cables — works with Sleipner panels, remotes and joystick systems
• Hold function — keeps a set level of thrust applied, useful when holding the boat against a pontoon
• Q-Prop™ five-blade skewed propeller — Sleipner measure up to 75% less noise than a conventional propeller
• Sealed electrics — , for petrol boats and wet installations
• Intelligent Power Control — soft start and minimal delay on direction change to reduce wear, with automatic protection
• Thermal protection — the thruster protects itself before the motor can be damaged
• Sealed drive lubrication and ceramic shaft seals — no oil feed to plumb
• Safe start-up — the control panel must be deliberately activated before the thruster will run

Power and battery

Draws 225A at 42 V nominal. Sleipner specify a battery of at least 383 CCA (EN) and an ANL 200 fuse. As a 48 V model it needs a 48 V supply at the thruster — usually a dedicated bank close to the unit, which we can specify with you. Size the cable with our battery bank and cable size calculator, and use the thruster size calculator to confirm ERL170 is the right size for your boat.

Manuals and documents

• User manual (PDF)
• EU Declaration of Conformity (PDF)
• Installation manual (PDF)
• Joystick integration overview for Sleipner thruster systems (PDF)
• DNV AiP Thruster retract composite housing SR Ø250 and Ø300 (PDF)

การสั่งซื้อ

Genuine Sleipner (Side-Power) product, part no. ERL170/250TC-48V. Special order from Sleipner — the lead time is usually 7–10 days, confirmed before payment, and units are typically air-freighted. Worldwide shipping with freight quoted at actual cost, never marked up. Sleipner’s manufacturer warranty applies (terms in the user manual); as a special-order item it is returnable only if faulty — see our นโยบายการคืนสินค้าและคืนเงิน.