Side-Power SRLP80 PRO™ einziehbares Bug-/Heckstrahlruder 24V

Über dieses Produkt

SRLP80 PRO™ retract bow/stern thruster 24V — 80kg of thrust (96kg at 24 V), sized by Sleipner for motor boats and sail boats of 10–15 m (33–49 ft). A retractable thruster: it deploys below the hull when you need it and retracts into its housing when stowed, so there is no open tunnel and no drag under way. Variable-speed PRO control over S-Link.

What you get, and what to order with it

This is the thruster unit as supplied by Sleipner. Retract thrusters install in their own hull housing — the installation manual below gives the hull cut-out and mould dimensions. You also need an S-Link control panel (a PJC211 or PJC212 joystick, or a Sleipner touch panel), an ANL 250 fuse and holder, and battery cable sized to the run. The matching items are listed under “You may also need” below, and we will check the whole kit against your boat before it ships.

Merkmale

• Variable-speed (PRO proportional) control — apply only the thrust the manoeuvre needs, quietly and precisely
• S-Link™ CAN-based control with plug-and-play signal cables — works with Sleipner panels, remotes and joystick systems
• Hold function — keeps a set level of thrust applied, useful when holding the boat against a pontoon
• Q-Prop™ five-blade skewed propellers (twin, counter-rotating) — Sleipner measure up to 75% less noise than a conventional propeller
• Intelligent Power Control — minimal delay on direction change to reduce wear, with automatic protection
• Overheat protection — the thruster protects itself before the motor can be damaged
• Sealed drive lubrication and ceramic shaft seals — no oil feed to plumb
• Flexible coupling between motor and drive to absorb shock loads

Power and battery

Draws 280A at 21 V nominal. Sleipner specify a battery of at least 520 CCA (EN) and an ANL 250 fuse. Size the cable with our battery bank and cable size calculator, and use the thruster size calculator to confirm SRLP80 is the right size for your boat.

Manuals and documents

• Product specification sheet (PDF)
• Installation manual (PDF)
• Joystick integration overview for Sleipner thruster systems (PDF)
• User manual (PDF)

Bestellung

Genuine Sleipner (Side-Power) product, part no. SRLP80/185T-24V. Special order from Sleipner — the lead time is usually 7–10 days, confirmed before payment, and units are typically air-freighted. Worldwide shipping with freight quoted at actual cost, never marked up. Sleipner’s manufacturer warranty applies (terms in the user manual); as a special-order item it is returnable only if faulty — see our Returns & Refunds Policy.